嵌入式计算机 | Flash电子盘 | 嵌入式显示器
常见问题 | 资料下载 | 驱动下载
 PC/104+ & ATX Boards                

PC/104+ boards are small computers packed into the industry standard PC/104+ form factor. Each PC/104+ board is a combination of specific baseboard (SB) and matching computer-on-module (CM) implementing of most of the functions.

Mini-ATX boards are small computers packed into the industry standard Mini-ATX form factor. Each Mini-ATX board is a combination of ATX baseboard, the same in all products, and the specific computer-on-module implementing of most of the functions.

SBC-iGLX Features

The "SB Option" column specifies the P/N code of the SB-iGLX carrier board required to have the particular feature. The "CM Option" column specifies the P/N code of the CM-iGLX required to have the particular feature. SBC-iGLX content is the combination of features provided by the attached CM-iGLX and the features implemented on the SB-iGLX. To have a particular feature, both the CM and SB options of that feature must be implemented.
"+" means that the feature is always available, regardless of P/N code.

Feature Specification SB
Option		 CM
Option
CPU
SDRAM
Flash Disk		 See Feature List of CM-iGLX module    
COM-A Rx/Tx only, RS-232 levels, RJ11 or DB9 connector + +
COM-B Rx/Tx only, RS-232/422/485 levels, 100-mil header X +
IDE UDMA ATA-100 interface. 40-pin FPC connector. + +
Ethernet One or two 10/100 Mb Ethernet ports, using Realtek RTL8139:
- 1st port from CoM
- 2nd port from the baseboard
RJ-45 connector and activity LED's provided in two options:
- From baseboard's front panel
- Through FPC and optional extension module
+
E2

F1
+
E
E
TFT Panel TFT (digital RGB) panel interface. 51-pos FPC connector for direct interface to certain TFT panels + +
LVDS Panel LVDS panel interface, through 100-mil header L +
CRT Monitor Analog RGB interface for CRT and FP monitors, through DB15 on the front panel or through FPC and optional module + +
Video Input Using SAA7113 video input processor V +
GPIO up to 8 lines, on common 100-mil header + +
PCMCIA & CardBus Slots with card guides, based on PCI1520 controller. Supports PCMCIA (16-bit) or CardBus (32-bit) standards, and card types I, II and III C1
C2		 +
+
Host USB Three USB Host ports, 480 Mbps. Header for Type-A cable/ connector.  Two ports on front panel + +
Sound I/O
Touchscreen		 Wolfson WM9715L controller supporting distinct audio and touchscreen functions. Header for standard cable/connectors for Microphone (mono), Line input and Speakers (stereo). Touchscreen controller for resistive panels, pins on 100-mil header. + AT
PC104 Standard PC/104 connector and signals. Implemented using IT8888 PCI-ISA bridge P +
PC104+ PCI bus through standard PC/104+ connector R +
RTC Battery Real time clock operated from on-board lithium battery + +
CAN Bus CAN Bus controller and driver with galvanic isolation and DC separation W +

Electrical, Mechanical and Environmental Specifications

Supply Voltage High efficiency switched power supply. Support of sleep mode.
Two supply options:
- Regulated 3.3V or 5.0V (3.3V valid only if module doesn't contain "A" option)
- Unregulated 12V to 48V, for telecom and automotive applications
Power Consumption 3W to 6W in full activity, depending on CPU speed and selected features
Below 200 mW in sleep mode
Dimensions Without front panel - 96 x 91 mm
With front panel - 111 x 91 mm
Height ranges from 10 mm to 22 mm, depending on the connectors assembled. The height specified includes the CM-iGLX module.
Operation temp (case)
Commercial:    0o to 70o C
Extended: -20o to 70o C
Industrial: -40o to 85o C.
Storage temperature -40o to 85o C
Relative humidity 10% to 90% (operation)
05% to 95% (storage)
Shock 50G / 20 ms
Vibration 20G / 0 - 600 Hz
MTBF > 100,000 hours
北京朝阳区祁家豁子甲8号马甸经典家园B座304室 010-82013580 传真：010-82028111
Copyright@1999 - 2006 LANDMARK. All rights reserved. 罗达麦海 版权所有. 京ICP备05030145号